SOFTWIN Internet Security 2010 User's Guide Page 332

  • Download
  • Add to my manuals
  • Print
  • Page
    / 356
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 331
Note
POP3 is one of the most widely used protocols for downloading e-mail messages
from a mail server. If you do not know the protocol that your e-mail client uses to
download e-mail messages, ask the person who configured your e-mail client.
BitDefender Internet Security 2010 doesn't scan Lotus Notes POP3 traffic.
You should also verify the following possible causes:
1. Make sure Antispam is enabled.
a. Open BitDefender.
b. Click the Settings button in the upper-right corner of the window.
c. In the Security Settings category, check the antispam status.
If Antispam is disabled, this is what is causing your problem. Enable Antispam
and monitor the antispam operation to see if the problem is fixed.
2. Although very unlikely, you may want to check if you (or someone else) configured
BitDefender not to mark spam messages as [spam].
a. Open BitDefender and switch the user interface to Expert Mode.
b. Click Antispam on the left-side menu and then the Settings tab.
c. Make sure option Mark spam messages in subject is selected.
A possible solution is to repair or reinstall the product. However, you may want to
contact BitDefender for support instead, as described in section Support (p. 316).
35.5. BitDefender Removal Failed
This article helps you troubleshoot errors that may occur when removing BitDefender.
There are two possible situations:
During removal, an error screen appears. The screen provides a button to run an
uninstall tool that will clean up the system.
The removal hangs out and, possibly, your system freezes. Click Cancel to abort
the removal. If this does not work, restart the system.
If removal fails, some BitDefender registry keys and files may remain in your system.
Such remainders may prevent a new installation of BitDefender. They may also
affect system performance and stability. In order to completely remove BitDefender
from your system, you must run the uninstall tool.
If removal fails with an error screen, click the button to run the uninstall tool to clean
up the system. Otherwise, proceed as follows:
1. Go to www.bitdefender.com/uninstall and download the uninstall tool on your
computer.
Troubleshooting
314
BitDefender Internet Security 2010
Page view 331
1 2 ... 327 328 329 330 331 332 333 334 335 336 337 ... 355 356

Comments to this Manuals

No comments